Toyota Land Cruiser 1988 Repair Manual page 77

EM-46 ENGINE MECHANICAL- Cylinder Block
EM4370
REMOVAL OF ENGINE
1. DRAIN ENGINE COOLANT
(See page C0-3)
2. DRAIN ENGINE OIL
3. REMOVE HOOD
4. REMOVE BATTERY AND BATTERY TRAY
5. DISCONNECT ACCELERATOR AND THROTTLE
CABLES
6. REMOVE AIR INTAKE HOSE, AIR FLOW METER
AND AIR CLEANER ASSEMBLY
(a) Disconnect the air flow meter connector and clamp.
(b) Disconnect following hoses:
• ISC hose
• Air pump hose
• Distributor hose
• PCV hose
• Three hoses from the intake chamber rear side
• Two hoses from the VCV of the charcoal canister
(c) Disconnect the air intake hose clamp.
(d) Remove the wing nut and loosen the three clips,
and remove the air intake hose, air flow meter and air
cleaner cap.
(e) Remove the air cleaner element.
(f) Remove the three bolts and air cleaner case.
7. REMOVE COOLANT RESERVOIR TANK
8. REMOVE RADIATOR
(See page C0-11)
9. DISCONNECT FOLLOWING WIRES AND
CONNECTORS
(a) Oil pressure connector
{b) High tension cord from ignition coil
(c) Neutral start switch and transfer connectors located
near the starter
(d) Front differential lock connector
(e) Starter wire and connector
(f) Ground strap from starter
(g) Oxygen sensor connectors
(h) Alternator wire and connector
(i) Cooling fan connector
(j) Check connector
(k) Connector on RH fender apron