Toyota Land Cruiser 1988 Repair Manual page 108

ENGINE MECHANICAL- Cylinder Block EM-77
EM4482
14. INSTALL PS PUMP
(a) Install the PS pump with the two bolts. Do not
tighten the bolts.
(b) Install the woodruff key, drive pulley with the plate
washer spring washer and mount nut.
(c) Install and adjust drive belt
(See page MA-4)
(d) Push on the drive belt to hold the pulley in place and
torque the pulley nut.
Torque: 480 kg-em (35ft-lb. 47 N·m)
15. CONNECT EFI WIRE HARNESS TO ECU
16.
17.
18.
19.
(a) Push in the EFI wire harness through the cowl
panel.
(b) Connect the four connectors.
(c) Install the glove box.
CONNECT FOLLOWING HOSES:
(a) Heater hoses
(b) Fuel hoses
(c) Transfer hose
(d) Brake booster hose
(e) PS air control valve hose
(f) AI hoses
(g) Distributor hose
(h) Emission control hoses
CONNECT FOLLOWING WIRES AND
CONNECTORS
(a) Oil pressure connector
(b) High tension cord from ignition coil
(c) Neutral start switch and transfer connectors located
near the starter
(d) Front differential lock connector
(e) Starter wire and connector
(f)
Ground strap from starter
(g) Oxygen sensor connectors
(h) Alternator wire and connector
(i)
Cooling fan connector
(j) Check connector
(k) Connector on RH fender apron
INSTALL RADIATOR
(See page C0-11)
INSTALL COOLANT RESERVOIR TANK