Toyota Land Cruiser 1988 Repair Manual page 283

CH-14 CHARGING SYSTEM -Alternator
CH0569
CH0594
CH0553
(d) Install the three through screws.
(e) Remove the stiff wire from the access hole.
(f) Check that the rotor rotates smoothly.
(g) Seal the access hole.
INSTALLATION OF ALTERNATOR
1. INSTALL ALTERNATOR
(a) Mount the alternator on the alternator bracket with
pivot bolt and nut. Do not tighten the bolt and nut.
(b) Install the adjusting bar with the two bolts and ad-
justing lock bolt. Do not tighten the adjusting lock
bolt.
(c) Install the air pump stay with the bolt and nut.
2. INSTALL DRIVE BELTS
(a) Install the drive belt.
(b) Using a belt tension gauge, adjust the belt tension.
(See page CH-3)
Drive belt tension: New belt 145
±
25 lb
Used belt 100
±
20 lb
(c) Tighten the pivot and adjusting lock bolts.
3.
CONNECT CONNECTOR AND WIRE TO
ALTERNATOR
4. CONNECT CABLE TO NEGATIVE TERMINAL OF
BATTERY
5.
PERFORM ON-VEHICLE INSPECTION
(See steps 5 to 7 on pages CH-4. 5)