Toyota Land Cruiser 1988 Repair Manual page 72

ENGINE MECHANICAL- Timing Gears and Camshaft EM-41
INSTALLATION OF TIMING GEARS AND
CAMSHAFT
(See page EM-33)
1. INSTALL CRANKSHAFT TIMING GEAR
(a) Put the timing gear on the crankshaft with timing
mark facing forward.
(b) Align the timing gear set key with the key groove of
the timing gear.
(c) Using SST and a hammer, tap in the timing gear.
SST 09214-6001 0
(d) Using a plastic-faced hammer, tap in the crankshaft
pulley set key.
2. INSTALL CAMSHAFT TIMING GEAR AND
CAMSHAFT ASSEMBLY
(a) Set the crankshaft timing gear with the key groove
facing upward by turning the crankshaft clockwise.
(b) Insert the camshaft into the cylinder block.
CAUTION: Be careful not to damage the
camshaft bearings.
(c) Align the timing marks of the crankshaft and
camshaft timing gears and mesh the gears.
NOTE: At this time, No 6 cylinder should be at TDC I
compression.