Toyota Land Cruiser 1988 Repair Manual page 78

ENGINE MECHANICAL- Cylinder Block
EM-47
EM4482
10. DISCONNECT FOLLOWING HOSES:
(a) Heater hoses
(b) Fuel hoses
(c) Transfer hose
(d) Brake booster hose
(e) PS air control valve hose
(f) AI hoses
(g) Distributor hose
(h) Emission control hoses
11. DISCONNECT EFI WIRE HARNESS FROM ECU
(a) Remove the glove box.
(b) Disconnect the four connectors.
(c) Pull out the EFI wire harness from the cowl panel.
12. REMOVE PS PUMP WITHOUT DISCONNECTING
HOSES
(a) Push on the drive belt to hold the pulley in place and
loosen the pulley nut.
(b) Loosen the idler pulley nut and adjusting bolt, and
remove the drive belt.
(c) Remove the pulley mount nut, drive pulley and
woodruff key.
(d) Remove PS mount bolts, and remove the PS pump
from the bracket.
13. REMOVE A/C COMPRESSOR WITHOUT
DISCONNECTING HOSES
(a) Disconnect the connector.
(b) Loosen the idler pulley nut and adjusting bolt, and
remove the drive belt.
(c) Remove the four compressor mount bolts.
(d) Put aside the compressor, and suspend it to the
fender apron with the string.
14. RAISE VEHICLE
CAUTION: Be sure the vehicle is securely sup-
ported.
15. REMOVE TRANSFER UNDER COVER