Toyota Land Cruiser 1988 Repair Manual page 8

INTRODUCTION - How to Use This Manual
IN-3
Illustration:
what to do and where
The procedures are presented in a step-by-step format:
• The illustration shows
what
to do and
where
to do it.
• The task heading tells
what
to do.
• The detailed text tells
how
to perform the task and gives
other information such as specifications and warnings.
Example:
~ Task heading: what to do
21. CHECK PISTON STROKE OF OVERDRIVE BRAKE
(a) Place SST and a dial indicator onto the overdrive
brake piston as shown in the figure.
SST 09350-30020 (09350-06120)
/
~
Set part No. Component part No.
/Detail text: how to do it
(b) Measure the stroke applying and releasing the com-
pressed air (4 - 8 kg/cm 2 , 57 - 114 psi or 392 -
785 kPa) as shown in the figure.
Piston stroke: 1.40- 1.70 mm (0.0551 - 0.0669 in.)
----Specification
This format provides the experienced technician with a FAST
TRACK to the information needed. The upper case task heading
can be read at a glance and only when necessary, the text
below it provides detailed information. Important specifications
and warnings always stand out in bold type.
REFERENCES
References have been kept to a minimum. However, when they
are required you are given the
page
to go to.
SPECIFICATIONS
Specifications are presented in bold type throughout the text in
the applicable step. You never have to leave the procedure to
look up your specs. All specifications are also found in Appen-
dix A, specifications, for quick reference.
WARNINGS, CAUTIONS, NOTES:
• WARNINGS are presented in bold type, and indicate there is
a possibility of injury to you or other people.
• CAUTIONS are also presented in bold type, and indicate the
possibility of damage to the components being repaired.
• NOTES are separated from the text but do not appear in
bold. They provide additional information to help you effi-
ciently perform the repair.