Toyota Land Cruiser 1988 Repair Manual page 102

Front
i
Oil Groove
ENGINE MECHANICAL- Cylinder Block EM-71
EM1494
EM1703
No.4~
No.3
~
EM1339
2. INSTALL UPPER THRUST WASHERS
Install the thrust washers under the No. 3 main bearing
cap position of the block with the oil grooves facing
outward.
3. PLACE CRANKSHAFT ON CYLINDER BLOCK
4. INSTALL NEW CRANKSHAFT REAR OIL SEAL
(a) Apply M P grease to the oil seal lip.
(b) Push in the oil seal until its surface is flush with the
cylinder block edge.
CAUTION: Be careful not to install the oil seal
slantwise.
5. INSTALL MAIN BEARING CAPS AND LOWER
THRUST WASHERS
(a) Apply seal packing to the main bearing installation
surface of the cylinder block.
Seal packing: Part No. 08820-00080 or
equivalent
CAUTION: Be careful not to apply seal packing
to the main bearing.
(b) Install the lower thrust washers on the No. 3 main
bearing cap with the grooves facing outward.
(c) Install the main bearing caps in their proper loca-
tion.