Toyota Land Cruiser 1988 Repair Manual page 183

Fl-52
Sprmg
EFI SYSTEM - Fuel System
Cold Start Injector
Terminal
Ignition
Switch
ST1
Cold Start
Injector
Start Injector
Time Switch
Point
Fl2420 F12482
ON-VEHICLE INSPECTION
INSPECT RESISTANCE OF COLD START INJECTOR
(a) Disconnect the cold start injector connector.
(b) Using an ohmmeter, measure the resistance be-
tween the terminals.
Resistance: 2- 4
Q
If the resistance is not as specified, replace the cold start
injector.
(c) Reconnect the cold start injector connector.
REMOVAL OF COLD START INJECTOR
1. DISCONNECT CABLE FROM NEGATIVE
TERMINAL OF BATTERY
2. DISCONNECT COLD START INJECTOR
CONNECTOR
3. REMOVE COLD START INJECTOR PIPE
(a) Put a suitable container or shop towel under the
injector pipe.
(b) Remove the two union bolts, four gaskets, pipe
clamp bolt and injector pipe.
NOTE: Slowly loosen the union bolts.
4. REMOVE COLD START INJECTOR
Remove the two bolts, cold start injector and gasket.