Toyota Land Cruiser 1988 Repair Manual page 184

EFI SYSTEM - Fuel System
Fl-53
SST (Hose) i---union Bolt
~
NewGasket
SST (Union}
~
SST (Wire)
F12347
INSPECTION OF COLD START INJECTOR
1. INSPECT INJECTION OF COLD START INJECTOR
WARNING: Keep clear of sparks during the test.
(a) Install SST (two unions) to the injector and delivery
pipe with new gaskets and the union bolts.
SST 09268-41 045
(b) Connect SST (hose) to the unions.
SST 09268-41 045
(c) Connect SST (wire) to the injector.
SST 09842-30050
(d) Put a container under the injector.
(e) Reconnect the battery negative (-) cable.
(f) Turn the ignition switch ON.
NOTE: Do not start the engine.
(g) Using a service wire, short terminals
+
B and FP of
the check connector.
(h) Connect the test probes of the SST (wire) to the
battery, and check that the fuel spray 'is as shown.
SST 09842-30050
CAUTION: Perform this check within the short-
est possible time.
2.
INSPECT LEAKAGE
(a) In the condition above, disconnect the test probes
of SST (wire) from the battery and check fuel leak-
age from the injector.
SST 09268-30050
Fuel drop: One drop or less per minute
(b) Disconnect the battery negative (-) cable.
(c) Remove SST and the service wire.
SST 09268-41045 and 09842-30050