Toyota Land Cruiser 1988 Repair Manual page 281

CH-12 CHARGING SYSTEM -Alternator
CHOSSS
CHOSSO
ASSEMBLY OF ALTERNATOR
(See page CH-6)
1. INSTALL RECTIFIER HOLDER TO STATOR
Hold the stator coil lead with needle-nose pliers while
soldering the leads.
CAUTION: Protect the rectifiers from heat.
2. INSTALL IC REGULATOR
Hold the IC regulator terminal with needle-nose pliers
while soldering the terminals.
CAUTION: Protect the rectifiers from heat.
3. INSTALL RECTIFIER END FRAME TO RECTIFIER
HOLDER
(a) Place the insulator washer on the positive ( +) stud
of the rectifier holder.
(b) Place the two cushions on the brush holder and
alternator terminal.
(c) Place the rectifier end frame on the rectifier holder.
(d) Check that the wires are not touching the rectifier
end frame.
(e) Place the two terminal insulators on the positive
( +) studs of the rectifier holder.
(f) Install the condenser and four nuts.