Toyota Land Cruiser 1988 Repair Manual page 282

Snap Ring
CHARGING SYSTEM- Alternator CH-13
CH0583
4. INSTALL DRIVE END FRAME, FAN AND PULLEY
TO ROTOR
(a) Slide the snap ring and spacer ring onto the rotor
shaft.
(b) Mount the rotor in a soft jaw vise.
(c) Slide the drive end frame and spacer collar.
(d) Slide the fan, pulley and spring washer onto the
rotor shaft.
(e) Install and torque the nut.
Torque: 900 kg-em (65 ft-lb, 88 N-m)
5. ASSEMBLE DRIVE END FRAME AND RECTIFIER
END FRAME
(a) Bend the rectifier lead wires back to clear the rotor.
(b) Using a curved tool, push the brushes in as far as
they will go and hold them in place by inserting a
stiff wire through the access hole in the rectifier end
frame.
(c) Assemble the drive end frame and the rectifier end
frame by inserting the rear bearing on the rotor shaft
into the rectifier end frame.