Toyota Land Cruiser 1988 Repair Manual page 254

IGNITION SYSTEM - Distributor IG-9
IG0838
IG0836
IG0840
REPLACEMENT OF DISTRIBUTOR
DRIVEN GEAR
1. REMOVE DRIVEN GEAR
(a) Using a grinder, grind the driven gear and straight
pin.
CAUTION: Be careful not to damage the gover-
nor shaft.
(b) Mount the driven gear in a vice.
(c) Using a pin punch and hammer, tap out the straight
pin.
(d) Remove the driven gear.
2. INSTALL NEW DRIVEN GEAR
(a) Slide a new driven gear onto the governor shaft.
(b) Position the drill mark on the driven gear and rotor
as shown.
{c) Install a new straight pin.
(d) Secure the ends of the straight pin.