Toyota Land Cruiser 1988 Repair Manual page 101

EM-70
No. 2 Compression
and Expander
Lower Side
Rail
No.1
Front
No.2
No.3
ENGINE MECHANICAL- Cylinder Block
Upper side
Rail
EM3598
No.4
EM4343
(c) Position the piston rings so that the ring ends are as
shown.
CAUTION: Do not align the end gaps.
3.
INSTALL CONNECTING ROD BEARINGS
(a) Align the bearing claw with the claw groove of the
connecting rod or connecting rod cap.
{b) Install the bearing in the connecting rod and rod
cap.
CAUTION: Install the bearings with the oil hole
in the connecting rod.
ASSEMBLY OF CYLINDER BLOCK
(See page EM-45)
NOTE:
• Thoroughly clean all parts to be assembled.
• Before installing the parts, apply new engine oil to all
sliding and rotating surfaces.
• Replace all gaskets, 0-rings and oil seals with new
parts.
1. INSTALL MAIN BEARINGS
NOTE:
• The outside diameter varies with each bearing.
• All main bearing have oil holes except No. 1 and No.
4 bearings on the lower side.
(a) Align the bearing claw with the the claw groove of
the main bearing cap or cylinder block.
(b) Install the bearing in the cylinder block and bearing
caps.
CAUTION: Install the bearing with the oil hole in
the block.