Toyota Land Cruiser 1988 Repair Manual page 332

AIR CONDITIONING SYSTEM -Compressor
AC-11
AC0696
\
AC0057
2. INSTALLSTATOR
(a) Install the stator on the compressor.
(b) Using SST, install the new'snap ring.
SST 07114-84020
(c) Connect the stator lead wires to the compressor
housing.
3. INSTALL ROTOR
(a) Install the rotor on the compressor shaft.
(b) Using SST, install the new snap ring.
SST 07114-84020
4. INSTALL PRESSURE PLATE
(a) Adjust the clearance between the pressure plate and
rotor by putting shims on the compressor shaft.
Standard clearance:
0.6 -1.0 mm (0.024- 0.039 in.)
If the clearance is not within tolerance, add or reduce the
number of shims to obtain the standard clearance.
{b) Using SST and torque wrench, install the shaft nut.
SST 07112-76040
Torque: 165 kg-em (12 ft-lb, 16 N·m)
5. CHECK CLEARANCE OF MAGNETIC CLUTCH
,___ _ _ _ _ _ _ _ _ _ _ _ _ A....;.co..,...ss;;;......j 7
(a) Set the dial-gauge to the pressure plate of the mag-
Dial-Gauge
AC0801
netic clutch.
(b) Connect the magnetic clutch lead wire to the posi-
tive ( +) terminal of the battery.
(c) Check the clearance between the pressure plate and
rotor, when connect the negative(-) terminal of the
battery.
Standard Clearance:
0.6-1.0 mm (0.024-0.039 in.}
If the clearance is not within standard clearance adjust
the clearance using shims to obtain the standard clear-
ance.