Toyota Land Cruiser 1988 Repair Manual page 43

EM-12
!,
'\
I '
ENGINE MECHANICAL- Cylinder Head
EM4368
EM43S4
REMOVAL OF CYLINDER HEAD
(See page EM-11)
1. DRAIN ENGINE COOLANT
(See page C0-3)
2. DISCONNECT CABLE FROM NEGATIVE
TERMINAL
3. REMOVE HOOD
4. DISCONNECT ACCELERATOR AND THROTTLE
CABLES
5. REMOVE AIR INTAKE HOSE, AIR FLOW METER
AND AIR CLEANER CAP
6.
7.
8.
(a) Disconnect the air flow meter connector and clamp.
(b) Disconnect following hoses:
• ISC hose
• Air pump hose
• Distributor hose
• PCV hose
• Three hoses from the intake chamber rear side
• Two hoses from the VCV of the charcoal canister
(c) Loosen the air intake hose clamp.
(d) Remove the wing nut and loosen the three clips,
and remove the air intake hose, air flow meter and air
cleaner cap.
REMOVE PS PUMP WITHOUT DISCONNECTING
HOSES
(a) Push on the drive belt to hold the pulley in place and
loosen the pulley nut.
(b) Loosen the idler pulley and adjusting bolts, and re-
move the drive belt.
(c) Remove the drive pulley and woodruff key.
(d) Remove PS mount bolts, and remove the PS pump
from the bracket.
REMOVE A/C COMPRESSOR WITHOUT
DISCONNECTING HOSES
(a) Disconneet the connector.
(b) Loosen the idler pulley nut.
(c) Screw in the adjusting bolt, and remove the drive
belt.
(d) Remove the four compressor mount bolts.
(e) Put aside the compressor, and suspend it to the
fender apron with the string.
REMOVE PS PUMP AND A/C COMPRESSOR
BRACKETS