Toyota Land Cruiser 1988 Repair Manual page 264

No continuity
STARTING SYSTEM- Starter ST-7
ST0019
ST0062
ST0020
I
ST0021 ST0041
Brush Springs
INSPECT BRUSH SPRING LOAD
Take the pull scale reading the instant the brush spring
separates from the brush.
Spring installed load:
1.79-2.41 kg (3.9- 5.3 lb. 18-24 N)
If the installed load is not within specification, replace
the brush springs.
Brush Holder
INSPECT BRUSH HOLDER INSULATION
Using an ohmmeter, check that there is no continuity
between the positive ( +) and negative (-) brush hold-
ers.
If there is continuity, repair or replace the brush holder.
Clutch and Gears
1. INSPECT GEAR TEETH
Check the gear teeth on the pinion gear, idler gear and
clutch assembly for wear or damage.
If damaged, replace the gear or clutch assembly.
If damaged, also check the drive plate ring gear for wear
or damage.
2. INSPECT CLUTCH
Rotate the clutch pinion gear clockwise and check that it
turns freely. Try to rotate the clutch pinion gear counter-
clockwise and check that it locks.
If necessary, re·place the clutch assembly.
Bearings
1. INSPECT BEARINGS
Turn each bearing by hand while applying inward force.
If resistance is felt or if the bearing sticks, replace the
bearing.