Toyota Land Cruiser 1988 Repair Manual page 63

EM-32 ENGINE MECHANICAL- Cylinder Head
21. INSTALL AIR INTAKE HOSE, AIR FLOW METER
AND AIR CLEANER CAP
(a) Install the air intake hose, air flow meter and air
cleaner cap with the wing nut and three clips. -
(b) Connect following hoses:
• ISC hose
• Air pump hose
• Distributor hose
• PCV hose
• Three hoses from the intake chamber rear side
• Two hoses from the VCV of the charcoal canister
22. CONNECT ACCELERATOR AND THROTTLE
CABLES, AND ADJUST THEM
23. FILL WITH ENGINE COOLANT (See page C0-3)
Capacity:
w I Front heater
17.5 liters {18.5 US qts, 15.4 Imp. qts)
w
I Front and rear heaters
19.5 liters (20.6 US qts, 17.2 Imp. qts)
24. CONNECT CABLE TO NEGATIVE TERMINAL OF
BATTERY
25. START ENGINE AND CHECK FOR LEAKS
26. PERFORM ENGINE ADJUSTMENT
(a) Adjust the ignition timing.
(See steps 10 to 14 on page IG-1 1)
Ignition timing: 7° BTDC @ idle
(wl Terminals TE1 and E1
short-circuited)
(b) Adjust the valve clearance. (See page EM-7)
Valve clearance (Hot):
Intake 0.20 mm (0.008 in.)
Exhaust 0.35 mm (0.014 in.)
27. INSTALL HOOD
28. PERFORM ROAD TEST
Check for abnormal noise, shock, slippage and smooth
operation.
29. RECHECK ENGINE COOLANT LEVEL AND OIL
LEVEL