Toyota Land Cruiser 1988 Repair Manual page 105

EM-74
ENGINE MECHANICAL- Cylinder Block
EM3555
EM4520
POST ASSEMBLY
1.
2.
3.
4.
5.
6.
7.
8.
INSTALL OIL PUMP AND OIL PAN
(See page LU-10)
INSTALL OIL COOLER AND OIL FILTER BRACKET
(See page LU-14)
INSTALL TIMING GEARS AND CAMSHAFT
(See page EM-41)
INSTALL WATER PUMP
INSTALL CYLINDER HEAD
(See page EM-28)
REMOVE ENGINE STAND
INSTALL TRANSMISSION HOUSING ADAPTOR
INSTALL DRIVE PLATE
(a) Clean the mount bolt threads and crankshaft bolt
holes of any residual sealer, oil foreign particles.
Remove any oil with kerosene or gasoline.
(b) Apply adhesive to two or three threads of the mount
bolt end.
Adhesive: Part No. 08833-00070, THREE BOND
1324 or equivalent
NOTE:
• This sealant will not harden while exposed to air.
• It will act as a sealer or binding agent only when ap-
plied to threads, etc. and the air is cut off.
(c) Install the drive plate on the crankshaft.
(d) Install and uniformly tighten the bolts in several
passes, in the sequence shown.
Torque: 890 kg-em (64 ft-lb, 87 N·m)