Chrysler Sebring 2005 Service Manual page 1541

21 - 130 40TE AUTOMATIC TRANSAXLE
GEAR SHIFT CABLE (Continued)
Fig. 202 Center Console Assembly
1 - CENTER CONSOLE
2 - SCREW
3 - IF EQUIPPED
4 - IF EQUIPPED
5 - PARK BRAKE HANDLE
(9) Loosen nut on shift cable adjust lever (Fig.
203).
Fig. 203 Shift Cable Adjust Lever Nut—Typical
1 - ACCESS HOLE
(10) Using a flat blade pry tool, remove the shifter
cable core end from the shift lever pin (Fig. 204).
(11) Using a flat blade pry tool, pry the cable con-
duit clip up from the shifter bracket. Pull up on the
cable conduit and remove from bracket (Fig. 204).
Fig. 204 Gearshift Cable at Floor Shifter
1 - CLIP
2 - CABLE
3 - CONDUIT BRACKET
4 - SHIFT PIN
(12) Raise vehicle on hoist.
(13) Remove the cable grommet from the floor pan
area (Fig. 205).
(14) Carefully remove the cable from the under-
body by unfolding the cable retainer clip (Fig. 205) as
you go along.
Fig. 205 Gearshift Cable Routing
1 - CABLE
2 - RETAINER CLIP
3 - GROMMET
JR