Chrysler Sebring 2005 Service Manual page 1419

21 - 8 T350 MANUAL TRANSAXLE
T350 MANUAL TRANSAXLE (Continued)
(16) Remove two snap rings retaining the output
shaft and the input shaft to the bearings (Fig. 19).
Fig. 19 Snap Rings Retaining Bearings
1 - SNAP RING PLIERS
2 - SNAP RINGS
(17) Using bench fixture and shims provided
(Miller tools # 6785, 6785-1, and 6785-2), turn trans-
axle over. Install transaxle onto bench fixture (Fig.
20). Verify shim spacers are in position on bench fix-
ture. Install transaxle into shop press.
Fig. 20 Bench Fixture
1 - SHIMS
2 - TRANSAXLE
3 - 6785 BENCH FIXTURE
(18) Install bearing fixture Miller tool #6768 onto
transaxle end bearings (Fig. 21). Verify tool is prop-
erly aligned to input and output shafts.
Fig. 21 Bearing Fixture
1 - BEARING FIXTURE
2 - TRANSAXLE CASE
CAUTION: The oil dams in the input and output
shafts can be damaged while pressing on the
shafts if the bearing fixture is not used properly.
(19) Install transaxle gear case into shop press.
Press output and input shaft assemblies out of case
(Fig. 22).
Fig. 22 Pressing Gears Out of Case
1 - BEARING FIXTURE
2 - PRESS RAM
3 - TRANSAXLE CASE
4 - BENCH FIXTURE
JR