Chrysler Sebring 2005 Service Manual page 1811

23 - 36 DOOR - FRONT
DOOR GLASS (Continued)
(5) Install the weatherstrip. Cycle the glass fully
down and up, open and close the door. Verify that the
top edge of the door glass is beneath the lip of the
weatherstrip.
UP-STOP ADJUSTMENTS
NOTE: For minor adjustments (up to 3mm), rear up
stop can be accessed without removing the door
trim panel. Remove the reflector plate (Fig. 8). The
jackscrew nut also acts as a minor adjustment up
stop. Loosen the nut and move up or down to
achieve the correct height. Do not adjust the jack-
screw, as this will affect the inboard/outboard
adjustments.
(1) Remove door trim panel. (Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - REMOVAL)
(2) Remove window switch from door trim panel,
to operate glass.
(3) Remove watershield as necessary to gain access
to the rear adjuster. Lifting up the flap in the water-
shield can access the front adjuster. (Fig. 10)
Fig. 10 FRONT ADJUSTER
1 - WATERSHIELD FLAP
2 - JACK SCREW
(4) With glass in the slightly lowered position to
relieve pressure on up stops prior to adjustment.
Loosen up stop fasteners. (Fig. 11) and (Fig. 12).
Fig. 11 FORWARD UP STOP ADJUSTMENT
1 - FORWARD UP STOP
2 - ADJUSTMENT BOLT
3 - CONTACT BOLT
Fig. 12 REAR UP STOP ADJUSTMENT
1 - REAR UP STOP
2 - UP STOP ADJUSTMENT NUT
JR