Sunroof Glass Panel; Removal; Installation; Adjustment - Chrysler Sebring 2005 Service Manual

23 - 134 SUNROOF

SUNROOF GLASS PANEL

REMOVAL

(1) Slide sunshade rearward to the open position.
(2) Move the glass panel to the vent position.
(3) Remove the glass panel screws on each side
(Fig. 3).
(4) Lift off glass panel and remove from vehicle.
Fig. 3 Sunroof Glass Panel Screws
1 - ATTACHING SCREWS

INSTALLATION

(1) Position glass panel on to mechanism.
(2) Start the six attaching screws.
(3) Close glass.
(4) Center glass in opening by running a business
card around the glass.
(5) Adjust front height of glass, just below roof
panel.
(6) Tighten front two screws.
(7) Adjust rear height of glass, just above roof
panel.
(8) Tighten remaining screws.
(9) Verify sunroof operation and alignment. Check
fit and adjust as necessary, (Refer to 23 - BODY/
SUNROOF/GLASS PANEL - DESCRIPTION).
ADJUSTMENTS

ADJUSTMENT

(1) Move the sunshade rearward to the open posi-
tion.
(2) Move the sunroof glass panel to the fully closed
position.
(3) Loosen the forward and center screws on each
side enough to make the front adjustment.
(4) Adjust the front of the sunroof glass panel 1
mm (1/32 inch) below the top surface of the roof
panel.
(5) Tighten the front two screws.
(6) Loosen the rear screws on each side enough to
make the rear adjustment.
(7) Adjust the rear of the sunroof glass panel 1
mm (1/32 inch) above the top surface of the roof
panel.
(8) Tighten the rear two screws.
(9) Check for proper fit. If not OK, repeat glass
panel adjustment. If OK, tighten the center two
screws.

SUNROOF GLASS PANEL SEAL

REMOVAL
(1) Remove sunroof glass panel. (Refer to 23 -
BODY/SUNROOF/GLASS PANEL - REMOVAL).
(2) Grasp the seal and pull seal away from the
glass panel. The seal is a one piece seal.
INSTALLATION
NOTE: Always position seal seam on center of the
passenger side of glass panel.
(1) Install seal on glass. Using care working the
seal around the glass, being careful not to over
stretch the seal while installing.
(2) Install sunroof glass panel.
(3) Test sunroof operation, adjust as necessary.
SUNROOF HOUSING DRAIN
HOSE
REMOVAL
FRONT HOSES
(1) Move glass panel to the fully closed position.
(2) Remove sunroof opening trim lace. (Refer to 23
- BODY/SUNROOF/OPENING
REMOVAL).
(3) Disconnect the control switch and wire connec-
tor.
(4) Remove headliner. (Refer to 23 - BODY/INTE-
RIOR/HEADLINER - REMOVAL).
(5) Disconnect the drain hose from the sunroof
housing (Fig. 4).
(6) Drain any liquid from hose connection, if nec-
essary.
(7) Attach new drain hose to old hose with tape
that is to be replaced.
(8) Work the old hose back and forth to loosen the
sealer.
(9) Pull the old hose out through the bottom and
the new hose through.
JR
TRIM LACE -