Chrysler Sebring 2005 Service Manual page 1300

JR
TIMING CHAIN COVER (Continued)
(11) Remove screws securing heater supply tube to
right frame rail. Reposition heater supply tube.
(12) Place a floor jack with wooden block under oil
pan to support engine.
(13) Remove right engine mount (Refer to 9 -
ENGINE/ENGINE MOUNTING/RIGHT MOUNT -
REMOVAL).
(14) Remove upper timing chain cover bolts.
(15) Raise vehicle on hoist.
(16) Remove remaining bolts securing timing chain
cover to engine (Fig. 114).
(17) Remove timing chain cover.
(18) Discard timing chain cover gasket. Remove
front crankshaft oil seal from cover.
Fig. 114 TIMING CHAIN COVER
1 - GASKET
2 - TIMING CHAIN COVER
3 - BOLT - M6
4 - BOLT - M10
INSTALLATION
(1) Inspect and clean timing chain cover sealing
surfaces.
(2) Before installing timing cover gasket apply a
1/8 inch bead of Mopar Engine RTV GEN II to the
parting lines between the oil pan and cylinder block
(Fig. 115).
(3) Install timing cover and gasket. Tighten M10
cover bolts to 54 N·m (40 ft. lbs.) and M6 bolts to 12
N·m (105 in. lbs.) (Fig. 114).
(4) Install front crankshaft oil seal using Special
Tool 6780-2 sleeve and 6780-1 installer.
(5) Lower vehicle.
ENGINE 2.7L DOHC
Fig. 115 TIMING CHAIN COVER SEALING
1 - PLACE A 1/8 INCH BEAD OF SEALER AT PARTING LINE
(6) Install right engine mount (Refer to 9 -
ENGINE/ENGINE MOUNTING/RIGHT MOUNT -
INSTALLATION).
(7) Install screws attaching heater supply tube to
right front frame rail area.
(8) Raise vehicle on hoist.
(9) Connect heater hose to supply tube at right
front frame rail area.
(10) Install AC/Generator belt tensioner/bracket
assembly.
(11) Install crankshaft vibration damper. (Refer to
9 - ENGINE/ENGINE
DAMPER - INSTALLATION)
(12) Install accessory drive belts (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
INSTALLATION).
(13) Install belt splash shield and right front
wheel.
(14) Lower vehicle.
(15) Install coolant pressure container (Refer to 7 -
COOLING/ENGINE/COOLANT RECOVERY PRESS
CONTAINER - INSTALLATION).
(16) Fill cooling system (Refer to 7 - COOLING/
ENGINE - STANDARD PROCEDURE).
(17) Connect negative battery cable.
9 - 231
BLOCK/VIBRATION