Chrysler Sebring 2005 Service Manual page 1213

9 - 144 ENGINE 2.4L DOHC
TIMING BELT AND SPROCKET(S) (Continued)
Fig. 122 Crankshaft and Camshaft Timing
1 - CAMSHAFT TIMING MARKS
2 - CRANKSHAFT TDC MARKS
3 - TRAILING EDGE OF SPROCKET TOOTH
Fig. 123 Timing Belt Tension Verification
1 - SPRING TANG
2 - TOLERANCE WINDOW
TIMING BELT TENSIONER &
PULLEY
REMOVAL
(1) Remove the timing belt (Refer to 9 - ENGINE/
VALVE TIMING/TIMING BELT AND SPROCKETS -
REMOVAL).
(2) Remove timing belt idler pulley (Fig. 124).
Fig. 124 Timing Belt Idler Pulley
1 - IDLER PULLEY
2 - BOLT
(3) Hold camshaft sprocket with Special Tool 6847
while removing bolt (Fig. 125). Remove both cam
sprockets.
(4) Remove rear timing belt cover fasteners and
remove cover from engine (Fig. 126).
(5) Remove lower bolt attaching timing belt ten-
sioner assembly to engine and remove tensioner a s
a n a s s e m bly (Fig. 127).
INSTALLATION
(1) Align timing belt tensioner assembly to engine
and install lower mounting bolt bu t d o n o t tig h te n
(Fig. 127). To properly align tensioner assembly—in-
stall one of the engine bracket mounting bolts (M10)
5 to 7 turns into the tensioner's upper mounting loca-
tion (Fig. 127).
(2) Torque the tensioner's lower mounting bolt to
61 N·m (45 ft. lbs.). Remove the upper bolt used for
tensioner alignment.
(3) Install rear timing belt cover and fasteners.
Torque fasteners to values specified in (Fig. 126).
JR