Chrysler Sebring 2005 Service Manual page 1839

23 - 64 EXTERIOR
LEFT FRONT WHEELHOUSE SPLASH SHIELD (Continued)
Fig. 12 WHEELHOUSE SPLASH SHIELD
1 - WHEELHOUSE SPLASH SHIELD
2 - PUSH PIN FASTENERS
INSTALLATION
(1) Install the wheelhouse splash shield and install
the 4 push pin fasteners.
(2) Install the transmission splash shield, the
seven push pin fasteners, and the three screws.
(3) Install the fender trim and the trim screws.
(4) Install the wheel assembly. (Refer to 22 -
TIRES/WHEELS - INSTALLATION)
RADIATOR SUPPORT
CROSSMEMBER
REMOVAL
(1) Release hood latch and open hood.
(2) Remove push-in fasteners attaching fascia/
grille to radiator support crossmember.
(3) Remove bolts attaching support braces to bot-
tom of radiator support crossmember.
(4) Remove bolts attaching crossmember to radia-
tor closure panel.
(5) Remove nuts attaching hood latch to radiator
support crossmember.
(6) Remove radiator support crossmember from
vehicle.
INSTALLATION
(1) Install radiator support crossmember to vehi-
cle.
(2) Install nuts attaching hood latch to radiator
support crossmember.
(3) Install bolts attaching crossmember to radiator
closure panel.
(4) Install bolts attaching support braces to bottom
of radiator support crossmember.
(5) Install push-in fasteners attaching fascia/grille
to radiator support crossmember.
(6) Close hood.
REAR WHEELHOUSE SPLASH
SHIELD
REMOVAL
(1) Remove the wheel. (Refer to 22 - TIRES/
WHEELS - REMOVAL)
(2) Remove the six push pin fasteners, two screws
and remove the wheelhouse splash shield (Fig. 13).
Fig. 13 WHEELHOUSE SPLASH SHIELD
1 - SPLASH SHIELD
2 - PUSH PIN FASTENERS
INSTALLATION
(1) Position the splash shield and install the six
push pin fasteners and two screws.
(2) Install the wheel. (Refer to 22 - TIRES/
WHEELS - INSTALLATION)
JR