Chrysler Sebring 2005 Service Manual page 1270

JR
CRANKSHAFT OIL SEAL - REAR (Continued)
Fig. 63 Rear Crankshaft Oil Seal Removal - Typical
1 - REAR CRANKSHAFT SEAL
2 - ENGINE BLOCK
3 - ENGINE BLOCK
4 - REAR CRANKSHAFT SEAL METAL CASE
5 - PRY IN THIS DIRECTION
6 - CRANKSHAFT
7 - SCREWDRIVER
8 - REAR CRANKSHAFT SEAL DUST LIP
9 - SCREWDRIVER
(4) Install drive plate and transaxle. (Refer to 21 -
TRANSMISSION/TRANSAXLE/AUTOMATIC - 42LE
- INSTALLATION)
CRANKSHAFT REAR OIL SEAL
RETAINER
REMOVAL
(1) Remove crankshaft rear oil seal and oil pan.
(Refer to 9 - ENGINE/ENGINE BLOCK/CRANK-
SHAFT OIL SEAL - REAR - REMOVAL) (Refer to 9 -
ENGINE/LUBRICATION/OIL PAN - REMOVAL)
(2) Remove seal retainer attaching screws (Fig.
65).
(3) Remove retainer and gasket (Fig. 65).
INSTALLATION
(1) Clean sealing surfaces and replace gasket as
needed.
(2) Install gasket and loose assemble seal retainer
to block.
NOTE: The following steps must be performed to
prevent oil leaks at sealing joints.
ENGINE 2.7L DOHC
Fig. 64 Crankshaft Rear Seal - Installation
1 - C-4171 HANDLE
2 - 6926–2 INSTALLER
3 - 6926–1 GUIDE
4 - SEAL
Fig. 65 Oil Seal Retainer
1 - SCREWS (7)
2 - SEAL RETAINER
(3) Attach Special Tools 8225 to pan rail using the
oil pan fasteners.
NOTE: Make sure that the "2.7L" stamped on the
special tool is facing the cylinder block (flat side of
tools against pan rail).
9 - 201