Chrysler Sebring 2005 Service Manual page 1101

9 - 32 ENGINE 2.0L DOHC
CAMSHAFT(S) (Continued)
(1) Lubricate all camshaft bearing journals, rocker
arms and camshaft lobes.
(2) Install all rocker arms in original positions, if
reused.
(3) Position camshafts on cylinder head bearing
journals. Install right and left camshaft bearing caps
No. 2 – 5 and right No. 6. Tighten M6 fasteners to 12
N·m (105 in. lbs.) in sequence shown in (Fig. 24).
(4) Apply Mopar Gasket Maker to No. 1 and No.
6 bearing caps (Fig. 25). Install bearing caps and
tighten M8 fasteners to 28 N·m (250 in. lbs.).
Fig. 24 Camshaft Bearing Cap Tightening Sequence
Fig. 25 Camshaft Bearing Cap Sealing
1 - 1.5 mm (.060 in.) DIAMETER BEAD OF MOPAR GASKET
MAKER
NOTE: Bearing end caps must be installed before
seals can be installed.
(5) Install camshaft oil seals (Refer to 9 -
ENGINE/CYLINDER
SEAL(S) - INSTALLATION).
(6) Install camshaft target magnet and camshaft
position sensor.
(7) Install cylinder head cover (Refer to 9 -
ENGINE/CYLINDER
COVER(S) - INSTALLATION).
(8) Install rear timing belt cover and camshaft
sprockets (Refer to 9 - ENGINE/VALVE TIMING/
HEAD/CAMSHAFT
HEAD/CYLINDER
TIMING BELT / CHAIN COVER(S) - INSTALLA-
TION).
(9) Install timing belt and front timing belt cover
(Refer to 9 - ENGINE/VALVE TIMING/TIMING
BELT/CHAIN AND
TION).
CYLINDER HEAD COVER
REMOVAL
(1) Remove ignition coil and plug wires.
(2) Disconnect PCV and make-up air hoses from
cylinder head cover.
(3) Remove the cylinder head cover fasteners.
(4) Remove cylinder head cover from cylinder
head.
CLEANING
Clean cylinder head and cover mating surfaces
using a suitable solvent.
INSPECTION
Inspect cover rails for flatness.
INSTALLATION
NOTE: Replace spark plug well seals when install-
ing a new cylinder head cover gasket.
(1) Install new cylinder head cover gaskets (Fig.
26) and spark plug well seals (Fig. 27).
(2) Replace cylinder head cover bolt seals (Fig. 28).
CAUTION: Do not allow oil or solvents to contact
the timing belt as they can deteriorate the rubber
and cause tooth skipping.
OIL
Fig. 26 Cylinder Head Cover Gasket and Spark Plug
HEAD
1 - SPARK PLUG WELL SEALS
2 - GASKET
SPROCKETS - INSTALLA-
Well Seals
JR