Chrysler Sebring 2005 Service Manual page 1810

JR
DOOR GLASS (Continued)
(5) Install door trim panel and inner belt weather-
strip.
INSTALLATION - JR-27 ONLY
(1) Carefully lower door glass through opening in
top of door. Verify that the front edge of the glass is
in the mirror flag glass channel.
(2) Position rear guide plate onto door glass and
install bolts.
(3) Install nuts attaching regulator lift channel to
door glass.
(4) Tighten all door glass fasteners to 7.3 N·m (65
in. lbs.).
(5) Install door speaker, if so equipped. (Refer to 8
- ELECTRICAL/AUDIO/SPEAKER
TION)
(6) Tighten window inner belt stabilizer.
(7) Install inner door belt weatherstrip. (Refer to
23 - BODY/WEATHERSTRIP/SEALS/FRONT DOOR
INNER BELT WEATHERSTRIP - INSTALLATION)
(8) Install the watershield. (Refer to 23 - BODY/
DOOR - FRONT/WATERSHIELD - INSTALLATION)
ADJUSTMENTS
ADJUSTMENT - JR-27 ONLY
NOTE: Verify that the door is properly adjusted to
the body prior to adjusting the door glass.
NOTE: Lower quarter glass to the full down position
while making door glass adjustments, unless other-
wise instructed.
TOP OF GLASS – INBOARD/OUTBOARD
ADJUSTMENTS
(1) Remove the access covers. Disengage front
cover by prying at its rear edge. Disengage rear cover
by prying at notch at bottom of reflector (Fig. 8) and
(Fig. 9)
(2) Remove the convertible top side rail weather-
strip from the location to be adjusted.
NOTE: Remove only one weatherstrip section at a
time or the glass to weatherstrip retainer measure-
ments will not be accurate.
(3) Using a 10 mm socket, loosen the jack screw
nuts. (Fig. 8) and (Fig. 9)
(4) Using a 3 mm allen wrench, rotate the jack
screw to achieve the proper gap between the door
glass and the weatherstrip retainer (Fig. 14). Tighten
all fasteners prior to measuring the gaps.
- INSTALLA-
1 - REFLECTOR
2 - TRIM PANEL
3 - JACK SCREW ACCESS HOLE
1 - TRIM PANEL
2 - ACCESS COVER
3 - JACK SCREW ACCESS HOLE
DOOR - FRONT
Fig. 8 REAR UP-STOP ACCESS HOLE
Fig. 9 FRONT JACK SCREW ACCESS HOLE
23 - 35