Removal; Installation; Front & Rear Door Opening; Front Door Glass Run Weatherstrip - Chrysler Sebring 2005 Service Manual

23 - 142 WEATHERSTRIP/SEALS
DRIP RAIL WEATHERSTRIP (Continued)
Fig. 6 Drip Rail Weatherstrip
1 - DRIP RAIL
2 - DRIP RAIL WEATHERSTRIP

INSTALLATION

(1) Place drip rail weatherstrip into position.
(2) Push drip rail weatherstrip on to the roof rail
pinch flange above door openings.
(3) Starting at the bottom of the A-pillar, push the
drip rail weatherstrip on to the windshield side molding.
(4) Position splash shield.
(5) Install two screws.
(6) Close front and rear doors.
FRONT & REAR DOOR
OPENING WEATHERSTRIP

REMOVAL

(1) Open door.
(2) Remove door sill plate.
(3) Pull weatherstrip from pinch flange around
door opening (Fig. 7).
INSTALLATION
Position the splice in the door opening weather-
strip in the center of the bottom of the opening and
reverse the preceding operation.
(1) Push weatherstrip on to pinch flange around
door opening.
(2) Install door sill plate.
(3) Close door.
FRONT DOOR GLASS RUN
WEATHERSTRIP
REMOVAL
(1) Remove door glass. (Refer to 23 - BODY/DOOR
- FRONT/DOOR GLASS - REMOVAL)
(2) Remove bolt attaching bottom of front lower
run channel to inner door panel.
Fig. 7 Door Opening Weatherstrips
1 - REAR DOOR WEATHERSTRIP
2 - A-PILLAR SEAL
3 - PINCH FLANGE
4 - FRONT DOOR WEATHERSTRIP
5 - WEATHERSTRIP
(3) Pull glass run weatherstrip from door glass
opening frame.
(4) Remove lower run channel through opening at
top of door (Fig. 8).
Fig. 8 Door Glass Run Weatherstrip
1 - GLASS RUN WEATHERSTRIP
2 - FRONT DOOR
INSTALLATION
(1) Install lower run channel through opening at
top of door.
(2) Push glass run weatherstrip to door glass open-
ing frame.
(3) Install bolt attaching bottom of front lower run
channel to inner door panel.
JR