Chrysler Sebring 2005 Service Manual page 1073

9 - 4 ENGINE 2.0L DOHC
ENGINE 2.0L DOHC (Continued)
The cylinders are numbered from front of the
engine to the rear. The firing order is 1–3–4–2.
The engine identification number is located on the
left side of the engine block at the bed plate/engine
block parting line near the crankshaft position sensor
(Fig. 2).
Fig. 2 Engine Identification
1 - ENGINE IDENTIFICATION LOCATION
2 - CRANKSHAFT POSITION SENSOR
DIAGNOSIS AND TESTING
ENGINE DIAGNOSIS - INTRODUCTION
Engine diagnosis is helpful in determining the
causes of malfunctions not detected and remedied by
routine maintenance.
These malfunctions may be classified as either
mechanical (e.g., a strange noise), or performance
(e.g., engine idles rough and stalls).
Refer to the Engine Mechanical and the Engine
Performance diagnostic charts, for possible causes
and corrections of malfunctions (Refer to 9 - ENGINE
- DIAGNOSIS AND TESTING - MECHANICAL)
(Refer to 9 - ENGINE - DIAGNOSIS AND TESTING
- PERFORMANCE).
For fuel system diagnosis, (Refer to 14 - FUEL
SYSTEM/FUEL DELIVERY - DIAGNOSIS AND
TESTING).
Additional tests and diagnostic procedures may be
necessary for specific engine malfunctions that can-
not be isolated with the Service Diagnosis charts.
Information concerning additional tests and diagno-
sis is provided within the following:
• Cylinder Compression Pressure Test
• Cylinder Combustion Pressure Leakage Test
• Engine Cylinder Head Gasket Failure Diagnosis
• Intake Manifold Leakage Diagnosis
• Hydraulic Lash Adjuster Noise Diagnosis
• Engine Oil Leak Inspection
JR