Installation Installation; Installation - Jr-27 Only - Chrysler Sebring 2005 Service Manual

JR
FRONT SEAT BACK (Continued)
(13) Remove bolt attaching recliner lead screw to
seat frame.
(14) Remove seat back from seat frame (Refer to
23 - BODY/SEATS/SEAT BACK - REMOVAL).
(15) Unscrew lead screw from recliner mechanism
(Fig. 9).
(16) Remove lead screw, spring and spring plate
(Fig. 10).
Fig. 9 Recliner Lead Screw
1 - RECLINER MECHANISM
2 - LEAD SCREW
3 - SEAT FRAME
Fig. 10 Recliner Lead Screw
1 - LEAD SCREW SPRING PLATE
2 - LEAD SCREW
INSTALLATION
INSTALLATION
(1) Position seat back on cushion.
(2) Install both pivot bolts and tighten 40 N·m (30
ft. lbs.).
NOTE: Do not reuse the recliner assembly attaching
bolts.
(3) Install bolts attaching recliner to seat back
frame and tighten to 12 N·m (9 ft. lbs.).
(4) Install seat cushion side shields.
(5) Install seat in vehicle.

INSTALLATION - JR-27 ONLY

(1) Screw recliner lead screw into recliner mecha-
nism. (Fig. 9).
WARNING: DO NOT PULL ON UPPER RECLINER
HANDLE OR RECLINER CABLE END AT ANY POINT
UNTIL THE LEAD SCREW IS REMOVED.
(2) Route recliner cable in front of metal strap at
bottom of the seat back frame (Fig. 11).
Fig. 11 Route Recliner Cable
1 - NEW CABLE ROUTING (DRIVER SEAT)
2 - BACK FRAME STRAP
(3) Position seat back to seat frame (Refer to 23 -
BODY/SEATS/SEAT BACK - INSTALLATION).
(4) Install bolt attaching recliner lead screw to
seat frame. Tighten bolt to 45 N·m (33 ft. lbs.)
torque.
(5) Install pivot bolts attaching seat back to seat
frame. Tighten bolts to 51 N·m (38 ft. lbs.) torque.
(6) Attach easy entry rod to seat back, passenger
side only.
(7) Install easy entry washer and E-clip, passenger
side only.
(8) Install seat cushion (Refer to 23 - BODY/
SEATS/SEAT CUSHION - INSTALLATION).
(9) Feed recliner cable through hole in seat
adjuster and engage cable eyelet to arm on seat
adjuster.
(10) Install new recliner cable eyelet clip to arm on
seat frame (Fig. 8).
SEATS 23 - 111