Chrysler Sebring 2005 Service Manual page 1831

23 - 56 DOORS - REAR
TRIM PANEL
REMOVAL
(1) Open rear door.
(2) Lower window.
(3) Open the screw cap from bottom of arm rest
pull cup and remove the screw (Fig. 12).
(4) Open the screw cap from behind door latch
handle and remove the screw.
(5) Remove the screws along the bottom of the
trim panel.
(6) Using a trim stick C-4755 or equivalent, disen-
gage clips holding perimeter of trim panel to rear
door.
(7) Remove trim panel from inner belt weather-
strip at top of door.
(8) Disconnect wiring harness at door opening.
(9) Remove top of trim panel from door.
(10) Disengage clip holding linkage to latch handle
(Fig. 13).
(11) Remove linkage from latch handle.
(12) Lift trim up and off lock button.
(13) Remove rear door trim panel from vehicle.
Fig. 12 Rear Door Trim Panel
1 - SCREW
2 - SCREW
3 - SCREW
4 - REAR DOOR TRIM PANEL
5 - REAR DOOR
Fig. 13 Linkage Clip
1 - DOOR TRIM PANEL
2 - LATCH RELEASE ROD
3 - CLIP
INSTALLATION
(1) Position rear door trim panel on vehicle.
(2) Connect linkage to latch handle.
(3) Engage clip holding linkage to latch handle.
(4) Connect wiring harness at door opening.
(5) Position the lock knob through the trim panel
and engage trim panel from inner belt weatherstrip
at top of door.
(6) Align the clips attaching perimeter of trim
panel to rear door with the grommets and engage.
(7) Install screws attaching door trim panel to
door. (Fig. 12)
(8) Install screw holding door latch handle to door
and close the screw cap.
(9) Install screw from bottom of arm rest pull cup
and close the screw cap.
(10) Connect battery.
JR