Chrysler Sebring 2005 Service Manual page 1819

23 - 44 DOOR - FRONT
TRIM PANEL
REMOVAL
(1) Roll door glass down.
(2) Disengage two clips attaching speaker grille to
door trim panel. They are at the front of the grille,
one near the top, and the other one at the bottom.
(3) Remove three large washer-headed screws sur-
rounding the speaker (Fig. 29).
(4) Remove access cover at front of door trim
panel. Remove by prying at its rear edge (Fig. 30).
(5) Remove red courtesy reflector from lower tail
or door. Disengage by prying at screwdriver notch at
bottom of reflector.
(6) Remove flag trim panel from door by prying off
at two attachment clips points (Fig. 30).
(7) Remove seven screws attaching door trim panel
to door: (Fig. 29) and (Fig. 30).
(a) One screw is located at lower rear screw
pocket.
(b) Three screws located along the bottom of
door.
(c) One screw located inside handle opening.
(d) One screw located at the upper front.
(e) One screw in the pull cup.
(8) Disengage two hidden clips attaching at the
rear of the trim panel, by prying off at two attach-
ment clip points.
(9) Lift trim panel upward and away from door,
disengage trim panel from upper retainer channel.
(10) Disengage clip attaching latch linkage to back
door handle.
(11) Disconnect electrical connectors as necessary,
including lower foot light, If equipped.
(12) Remove door trim panel from door.
Fig. 29 Lower Door Trim Panel Removal
1 - SCREWS AT SPEAKER LOCATION
2 - BOTTOM OF DOOR TRIM PANEL
Fig. 30 Mirror Bezel and Door Trim Access Cover
1 - FLAG TRIM PANEL
2 - DOOR TRIM ACCESS COVER
3 - INSIDE REMOTE HANDLE
4 - POWER DOOR LOCK SWITCH
INSTALLATION
(1) Position door trim panel near to door.
(2) Connect electrical connectors as necessary,
including foot light, if so equipped.
(3) Engage clip attaching latch linkage to inside
door handle.
(4) Lift the door trim slightly to get the lock knob
into its bezel opening on the panel.
(5) Place front portion of upper trim strip flange
into retainer channel, while seating white forward
locator pin into mating hole in sheet metal at front of
door.
(6) Drive screw into forward locator cup.
(7) With rear of panel slightly lifted, engage
remainder of trim strip flange into retainer channel,
working from front to back, pressing down firmly.
(8) Engage two hidden clips attaching rear of door
trim to their mating (green) grommet holes in the
door. Press the rear of the panel firmly in toward the
door, listening for engagement clicking sounds at
BOTH of the clips.
(9) Install seven screws attaching door trim panel
to door: (Fig. 29) and (Fig. 30).
(a) One screw in the pull cup.
(b) One screw located inside handle opening.
(c) One screw located at the upper front.
(d) One screw is located at lower rear screw
pocket.
(e) Three screws located along the bottom of
door.
(10) Snap screw covers closed.
(11) Install three large washer headed screws sur-
rounding the speaker (Fig. 29).
JR