Chrysler Sebring 2005 Service Manual page 1362

JR
IDLE AIR CONTROL MOTOR (Continued)
• Battery voltage
• Ambient/Battery Temperature Sensor
• VSS
• TPS
• MAP Sensor
REMOVAL
REMOVAL - 4 CYLINDER
When servicing throttle body components, always
reassemble components with new O-rings and seals
where applicable. Never use lubricants on O-rings or
seals, damage may result.
(1) Disconnect negative cable from battery.
(2) Remove electrical connector from idle air con-
trol valve.
(3) Remove idle air control valve mounting screws
(Fig. 15).
(4) Remove motor from throttle body. Ensure the
O-ring is removed with the valve.
REMOVAL - 2.7L
(1) Disconnect the negative battery cable.
(2) Disconnect the IAC electrical connector (Fig.
17).
Fig. 17 Idle Air Control Valve
1 - THROTTLE POSITION SENSOR
2 - IDLE AIR CONTROL VALVE
(3) Remove the IAC mounting screw.
(4) Remove the IAC.
INSTALLATION
INSTALLATION - 4 CYLINDER
When servicing throttle body components, always
reassemble components with new O-rings (Fig. 18)
and seals where applicable.
Fig. 18 O-RINGS
1 - O-rings
(1) The new idle air control valve has a new O-ring
installed on it.
(2) Carefully place idle air control valve into throt-
tle body (Fig. 15).
(3) Install mounting screw. Tighten screw to 4.5
N·m (40 in. lbs.) torque.
(4) Connect electrical connector to idle air control
valve
(5) Connect negative cable to battery.
INSTALLATION - 2.7L
(1) Install the IAC to the throttle body (Fig. 17).
(2) Tighten mounting screws to 5.1 N·m (45 in.
lbs.) torque.
(3) Attach electrical connector to the IAC.
(4) Connect the negative battery cable.
FUEL INJECTION 14 - 27