Chrysler Sebring 2005 Service Manual page 1123

9 - 54 ENGINE 2.0L DOHC
FRONT MOUNT (Continued)
Fig. 79 FRONT ENGINE MOUNT
1 - HORIZONTAL THROUGH BOLT
2 - VERTICAL BOLT(S)
3 - LOWER RADIATOR CROSSMEMBER
4 - FRONT ENGINE MOUNT
NOTE: Be sure the weight of the engine is static
and in rest position.
(4) Tighten the rear horizontal through bolt to 75
N·m (55 ft. lbs.) (Fig. 80)
(5) Tighten the front horizontal through bolt to 75
N·m (55 ft. lbs.) (Fig. 79).
(6) Lower vehicle.
REAR MOUNT
REMOVAL
(1) Remove throttle body air inlet hose and air
cleaner housing assembly.
(2) Remove three vertical bolts attaching rear
mount bracket to transaxle case (Fig. 80).
(3) Raise vehicle on hoist.
(4) Remove rear mount bracket through bolt (Fig.
80).
(5) Remove horizontal bolt attaching rear mount
bracket to transaxle case (Fig. 80).
(6) Loosen front mount though bolt.
(7) Remove mount bracket.
(8) Remove rear mount to suspension crossmember
attaching bolts.
(9) Remove rear mount.
Fig. 80 Engine Mounting—Rear
1 - REAR TORQUE BRACKET
2 - REAR MOUNT
3 - THROUGH BOLT
INSTALLATION
(1) Position rear mount on suspension crossmem-
ber and loosely install bolts.
(2) Position mount bracket on transaxle and install
bolts. Tighten to 95 N·m (70 ft. lbs.) (Fig. 80).
(3) Tighten rear mount to crossmember bolts to 61
N·m (45 ft. lbs.) (Fig. 80)
NOTE: Be sure the weight of the engine is static
and in rest position.
(4) Install rear mount to bracket through bolt and
tighten rear mount through bolt to 75 N·m (55 ft.
lbs.) (Fig. 80).
(5) Tighten front mount through bolt to 75 N·m
(55 ft. lbs.) (Fig. 79)
(6) Lower vehicle. Install throttle body air inlet
hose and air cleaner housing assembly.
JR