Chrysler Sebring 2005 Service Manual page 1470

Hide thumbs Also See for Sebring 2005:

Table of Contents

40TE AUTOMATIC TRANSAXLE (Continued)

(24) Remove front carrier/rear annulus assembly

and #6 needle bearing (Fig. 32).

Fig. 32 Remove Front Carrier/Rear Annulus

1 - #6 NEEDLE BEARING

2 - FRONT CARRIER AND REAR ANNULUS ASSEMBLY (TWIST

AND PULL OR PUSH TO REMOVE OR INSTALL).

(25) Remove rear sun gear and #7 needle bearing

NOTE: The number 7 needle bearing has three anti-

reversal tabs and is common with the number five

and number two position. The orientation should

allow the bearing to seat flat against the rear sun

gear (Fig. 34). A small amount of petrolatum can be

used to hold the bearing to the rear sun gear.

Fig. 33 Remove Rear Sun Gear

1 - #7 NEEDLE BEARING

2 - REAR SUN GEAR

40TE AUTOMATIC TRANSAXLE

Fig. 34 Number 7 Bearing

1 - #7 NEEDLE BEARING

2 - REAR SUN GEAR

(26) Setup tool 5058 as shown in (Fig. 35). Com-

press 2/4 clutch return spring (just enough to remove

snap ring) and remove snap ring.

NOTE: Verify that Tool 5058 is centered properly

over the 2/4 clutch retainer before compressing. If

necessary, fasten the 5058 bar to the bellhousing

flange with any combination of locking pliers and

bolts to center the tool properly.

Fig. 35 Remove 2/4 Clutch Retainer Snap Ring

1 - TOOL 5058

2 - SCREWDRIVER

3 - SNAP RING

4 - 2/4 CLUTCH RETAINER

Chapters

Table of Contents

Sebring convertible 2005 Stratus 2005