Advanced Configuration; Initialisation - NetComm NTC-220 User Manual

Advanced configuration

To access the web-based user interface, open a web browser (e.g. Mozilla Firefox or Google Chrome), type
https://192.168.1.1 into the address bar and press Enter.
The router's web user interface is displayed.
Important – The HTTP protocol is disabled by default, secure HTTP (HTTPS) is the default protocol. HTTP access is available but must be
manually enabled.

Initialisation

The first time the device is booted (or booted after it is factory reset), the device enters "Configuration mode". In
Configuration mode, the router runs a setup wizard which must be completed before it will boot into "Live mode".
This is a security feature which enables you to set strong passwords for web root, web user, and Telnet/SSH access
or restore a previous configuration from a file.
To complete the setup:
1 Click the Next button on the first dialogue box.
2 Enter the factory default password which is printed on the device label then click the Next button.
3 Select whether to configure the router as a new device or to restore a previous configuration backup.
NTC-220 – User Guide
UG01028 v1.2 March 2019
22 of 193
© NetComm Wireless 2019