NetComm NTC-220 User Manual page 152

O P T I O N
Remote router access control
Note that all remote router access control settings are disabled by default.
Enable HTTP
HTTP management
port
Enable HTTPS
Remote HTTPS
access port
HTTPS source IP
whitelist
Enable Telnet
Enable SSH
Remote SSH Access
Port
Enable FTP
Enable FTPS
Enable Ping
Local router access control
Enable HTTP
Enable HTTPS
NTC-220 – User Guide
UG01028 v1.2 March 2019
Enable or disable remote HTTP access to the router.
When HTTP is enabled (see previous) you can set the HTTP
management port.
Enter a port number between 1 and 65534 to use when accessing
the router remotely.
Enable or disable remote HTTPS access to the router using a secure
connection.
When HTTPS is enabled (see previous) you can set the HTTPS
remote access port.
Enter a port number between 1 and 65534 to use when accessing
the router remotely over a secure HTTPS connection.
When HTTPS is enabled (see Enable HTTPS above) you can enter a
'whitelist' of IP addresses that will be permitted to access the router.
Enter a list of comma-separated unicast IP addresses. You may also
enter IP addresses in CIDR notation, however, no spaces are
permitted.
Note that if this field is left blank, all IP addresses will be permitted
to access the router.
Enable or disable remote telnet (command line) access to the router.
Enable or disable Secure Shell on the router.
When SSH is enabled (see previous) you can set the remote SSH
access port.
Enter the port number for remote SSH access.
The port number must be between 1 and 65534.
Enable or disable the File Transfer Protocol on the router for remote
connections.
Enable or disable the Secure File Transfer Protocol on the router for
remote connections.
Enable or disable remote ping responses on the WWAN connection.
Enable or disable local HTTP access to the router. The default
setting is disabled.
Enable or disable local secure HTTP access (https).
D E F I N I T I O N
152 of 193
© NetComm Wireless 2019