NetComm NTC-220 User Manual page 92

I T E M
Enable auto answer
Circuit auto answer
rings
Advanced status
Echo enable
Quiet mode
Send OK on carriage
return
Suppress line feeds
Send OK on
unknown command
Verbose mode
PPP server: This creates a point-to-point server endpoint with the following options.
NTC-220 – User Guide
UG01028 v1.2 March 2019
• Always On: RI is always on.
• Incoming Ring: RI is on when an incoming connection request is
received.
• Always Off: RI is always off
When enabled, the router accepts incoming connections.
Sets the number of incoming rings after which the router will answer
incoming circuit switched data calls. The default value is Off. The
other available options are from 1 to 12.
Enables echo on the serial side. All commands are echoes. This can
be turned on/off via ATE1 and ATE0 commands. Recommended
setting for this option is ON.
When on, there is no output from the modem on the serial side, i.e.
you do not see OK, Connect etc. Recommended setting for this
option is OFF.
If enabled, will print OK every time CR is received on the serial side.
Recommended setting for this option is ON.
If enabled, line termination is using CR (13). If disabled, line
termination is CR LF (13 10).
Recommended setting for this option is OFF.
Will send OK when an unknown/invalid AT command is received.
Recommended setting for this option is ON.
The modem returns messages to the computer to indicate the return
status of commands and interrupts such as incoming call and call
progress.
Recommended setting for this option is ON.
Table 20 – Modem emulator endpoint options
Figure 101 – PPP server endpoint configuration
D E S C R I P T I O N
92 of 193
© NetComm Wireless 2019