Geofence - NetComm NTC-220 User Manual

Geofence

To access the Geofence screen, select the Services item from the top menu bar then the GPS item on the left.
Finally, select the Geofence menu item.
Geofence allows you to designate a circular area and then uses the router's GPS position to monitor when the
NTC-220 series router moves out of or in to that area. You can configure notifications to be sent when the unit
enters or exits the region. Notifications types are set on the Event notification configuration page, see below.
Geofence operation button
Save button
Add button
Geofence list
Display DMS /
Display Decimal degree
button
Display imperial/
Display metric button
Status
Notification
NTC-220 – User Guide
UG01028 v1.2 March 2019
Figure 118 – Geofence options
I T E M
Toggles Geofence operation On or Off.
When on your currently defined Geofences appear in the
Geofence list, see below.
Saves any changes made on this page
Click to add a new Geofence definition.
The add Geofence configuration screen will open, see next
section below.
This table contains all your currently defined Geofences.
Toggle the Latitude and Longitude coordinates display
between Decimal degree coordinates, see above graphics,
or the more traditional DMS (degrees, minutes, seconds)
coordinates, see below:
Toggle between metric (kilometres) or imperial (miles)
display of the radius of the Geofence.
In if the router is inside the radius.
Out if the router is outside the radius.
The event notification currently selected for this Geofence,
see Add Geofence in next section for a description of the
available notification types.
D E S C R I P T I O N
110 of 193
© NetComm Wireless 2019