NetComm NTC-220 User Manual page 111

Edit button
Add Geofence
Click the +Add button to create a new Geofence (note that editing an existing Geofence uses the same
configuration page).
I T E M
Name
Display DMS / Display
decimal degree button
NTC-220 – User Guide
UG01028 v1.2 March 2019
I T E M
Click this to edit an existing Geofence in the list.
The user interface is the same as the add Geofence
configuration screen, see next section below.
Table 29 – Geofence user interface
Figure 119 – Configure Geofences
When you Add a new Geofence you will be prompted to enter
a meaningful name.
This will be its reference in the Geofence list page.
Toggle this button to enter the Latitude and Longitude
coordinates using either the more traditional DMS (degrees,
minutes, seconds) coordinates or using decimal degrees.
When Display DMS is selected you have to select North (N) or
South (S) for your Latitude, depending on whether your location
is north or south of the equator and you must select east (E) or
west (W) of the prime meridian (Greenwich England to the
international date line) and then enter the coordinates as:
0° - 360°
Whole
degrees
only
When Display decimal degree is selected you have to enter the
Latitude and Longitude coordinates using Decimal degree
coordinates:
D E S C R I P T I O N
D E S C R I P T I O N
D E G R E E S M I N U T E S
0' – 60'
Whole
minutes
only
S E C O N D S
0.0000" – 59.9999"
Seconds and
fractions of a
second to
thousandths (4)
© NetComm Wireless 2019
111 of 193