Appendix B: Default Settings - NetComm NTC-220 User Manual

Table 54 - RS-232 Wiring ..................................................................................................................................................................... 180
Table 55 - RS-485 Half Duplex Wiring ................................................................................................................................................ 180
Table 56 - RS-485 (RS-422) Full Duplex Wiring ................................................................................................................................... 180

Appendix B: Default settings

The following tables list the default settings for the NTC-220 series router.
Default root and admin passwords are printed on the label on the bottom of the router and on the back of the
Quick Start Guide which came in the box with your device.
Restoring factory default settings
Restoring factory defaults will reset the NTC-220 series router to its factory default configuration. You may
encounter a situation where you need to restore the factory defaults on your NTC-220 series router such as:
You have lost your username and password and are unable to login to the web configuration page;
You are asked to perform a factory reset by support staff.
There are two methods you can use to restore factory default settings on your NTC-220 series router:
Using the web-based user interface
Using the reset button on the interface panel of the router (if the button is enabled)
Using the web-based user interface
To restore your router to its factory default settings, please follow these steps:
1 Open a browser window and navigate to the IP address of the router (default address is
https://192.168.1.1
2 Click the System item from the top menu bar, then System configuration on the left menu and then click
Settings backup and restore.
3 Under the Restore factory defaults section, click the Restore defaults button. The router asks you to confirm
that you wish to restore factory defaults. Click OK to continue. The router sets all settings to default. Click
OK again to reboot the router.
4 When the Power light returns to a steady red, the reset is complete. The default settings are now restored.
Using the reset button on the interface panel of the router
If the reset button is enabled, use a pen to depress the Reset button on the device for 15-20 seconds. The router
will restore the factory default settings and reboot.
When you have reset your NTC-220 series router to its default settings you will be able to access the device's
configuration web interface using
NTC-220 – User Guide
UG01028 v1.2 March 2019
L A N ( M A N A G E M E N T )
Static IP Address
Subnet Mask
Default Gateway
Table 52 – LAN Management Default Settings
). Login to the router using root as the User Name and admin as the password.
https://192.168.1.1
192.168.1.1
255.255.255.0
192.168.1.1
with username user or root and password admin.
172 of 193
© NetComm Wireless 2019