Usb-Otg - NetComm NTC-220 User Manual

USB-OTG

The USB port can be enabled or disabled on the USB OTG configuration page (System > USB OTG). By default,
the port is enabled.
When the port is enabled, the USB-OTG page displays the current status of the USB port, i.e. whether it is in
Device mode or Host mode.
By default, Automatic mode is set to ON, allowing the router to intelligently choose the correct mode. If you wish
to manually override this selection, turn Automatic mode to OFF and manually select either Host or Device mode.
A notification can be sent each time a change to these settings is saved. To configure notification settings, go to
Services > Event notification > Notification configuration and select a notification type and destination for event
23.
NTC-220 – User Guide
UG01028 v1.2 March 2019
Figure 157 – USB-OTG configuration
166 of 193
© NetComm Wireless 2019