Creating A Mac / Ip / Port Filtering Rule - NetComm NTC-220 User Manual

Important – When enabling MAC / IP / Port filtering and setting the default rule to "Dropped", you should ensure that you have first added
a filtering rule which allows at least one known MAC/IP to access the router, otherwise you will not be able to access the user interface of
the router without resetting the router to factory default settings.

Creating a MAC / IP / Port filtering rule

To create a filtering rule:
1 Click the MAC / IP / Port filtering toggle key to switch it to the ON position.
2 Using the Default rule (inbound/forward) drop-down list, select the default action for the router to take when
traffic reaches it. By default, this is configured to Accepted. If you change this to Dropped, you should first
configure a filter rule that allows at least one device access to the router, otherwise you will effectively be
locked out of the router.
3 Click the Save button to confirm the default rule.
4 In the Current MAC / IP / Port filtering rules in the effect section, click the +Add button.
NTC-220 – User Guide
UG01028 v1.2 March 2019
Figure 71 – MAC / IP / Port filtering
Figure 72 – Current MAC / IP/ Port filtering rules in effect
66 of 193
© NetComm Wireless 2019