System Log Settings - NetComm NTC-220 User Manual

System log settings

To access the System log settings page, click on the System menu item then select the Log menu on the left and
then select System log settings from the drop-down menu.
Log data is stored in RAM and therefore when the unit loses power or is rebooted the RAM will lose any log
information stored in the RAM. To ensure that log information is accessible between reboots of the router there
are two options:
Enable the Log to non-volatile memory option.
Use a Remote syslog server.
Log capture level
The log capture level defines the amount of detail that the system log stores. This setting also affects the Display
level setting on the System log page, for example, if this is set to a low level, such as "Error", the System log will
not be able to display higher log levels.
I T E M
Debug
Info
Notice
Warning
Error
NTC-220 – User Guide
UG01028 v1.2 March 2019
Figure 135 – System log settings
Show extended system log messages with full debugging level details.
Show informational messages only.
Show normal system logging information.
Show warning messages only.
Show error condition messages only.
Table 48 – System log detail levels
D E F I N I T I O N
144 of 193
© NetComm Wireless 2019