Sms Diagnostics Examples - NetComm NTC-220 User Manual

SMS diagnostics examples

The examples below demonstrate various combinations of supported commands. This is not an exhaustive list and
serves as an example of possibilities only.
If the default setting of Only accept authenticated SMS messages is enabled:
Password authentication is required. Add your password followed by a space as a prefix to the command, for
example
If authentication required:
PASSWORD set username= "NetComm"
If authentication not required:
set username='NetComm'
Note – The authentication setting is located in the user interface at Services > SMS messages> Diagnostics.
D E S C R I P T I O N
Send SMS to change the data connection
username
Send SMS to change the data connection
password
Send SMS to change the data connection
authentication
Send SMS to reboot
Send SMS to check the WAN IP address
Send SMS to check the mobile signal
strength
Send SMS to check the IMEI number
Send SMS to check the current band
Send SMS to Disconnect (if connected) and
reconnect the data connection
Send SMS to disconnect the data connection
Send SMS to connect the data connection
Send multiple get command
Send multiple set command
Send SMS to reset to factory default settings
Send SMS to retrieve status of router
Send SMS to retrieve the history of the
session, including start time, end time and
total data usage
Send SMS to configure the router to send
syslog to a remote syslog server
NTC-220 – User Guide
UG01028 v1.2 March 2019
I N P U T C O M M A N D ( W I T H O U T P A S S W O R D P R E F I X )
set username='NetComm'
set password= `NetComm`
set authtype= 'pap'
execute reboot
get wanip
get rssi
get imei
get band
execute pdpcycle
execute pdpdown
execute pdpup
get wanip; get rssi
set ssh.genkeys=1; set username=test; set auth=pap
execute factorydefaults
get status
get sessionhistory
set syslogserver=123.209.56.78
138 of 193
© NetComm Wireless 2019