NetComm NTC-220 User Manual page 134

C O M M A N D N A M E
set pppoe set pppoe=1,1,1,test
get ledmode get ledmode
set ledmode set ledmode=10
get ssh.proto get ssh.proto
set ssh.proto set ssh.proto=1,2
get ssh.passauth get ssh.passauth
set ssh.passauth set ssh.passauth=1
get ssh.keyauth get ssh.keyauth
set ssh.keyauth Set ssh.keyauth=1
get get download.timeout
download.timeout
set
set download.timeout=20
download.timeout
get install.timeout
get install.timeout
set install.timeout set install.timeout=5
get sw.version get sw.version
NTC-220 – User Guide
UG01028 v1.2 March 2019
E X A M P L E
Table 39 – List of get/set commands
D E S C R I P T I O N
Sets PPPoE on, debug logging on, Forward WAN IP
on, and service name to "test".
Returns the status of the LED operation mode.
Sets the LED operation mode to be always on or to
turn off after the specified number of minutes.
Returns the SSH protocol in use.
Sets the SSH Protocol to protocol 1, 2 or both (1,2).
Returns the status of the SSH Enable password
authentication option.
Sets the SSH Enable password authentication option
on or off.
Returns the status of the SSH Enable key
authentication option.
Sets the SSH Enable key authentication option on or
off.
Returns the time in minutes that the router waits
before a download times out.
Sets the time in minutes that the router waits before
a download times out. This is set to 10 minutes by
default. Supported range is 10 – 1440 minutes.
Returns the time in minutes that the router waits
before a file that is being installed times out.
Sets the time in minutes that the router waits before
a file that is being installed times out. This is set to 3
minutes by default. Supported range is 3 – 300
minutes.
Returns the software version of the router.
134 of 193
© NetComm Wireless 2019