NetComm NTC-220 User Manual page 55

To configure the ping monitoring method:
1 Select the Edit button corresponding to the interface with the lowest metric (highest priority).
2 Use the Monitoring method drop-down list to select Ping.
3 In the First destination address field, enter a website address or IP address to which the router should send
the first round of ping requests.
4 In the Second destination address field, enter a website address or IP address to which the router should
send the second round of ping requests.
5 In the Periodic Ping timer field, enter an integer between 3 and 65535 for the number of seconds the router
should wait between ping attempts.
6 In the Retry timer field, enter an integer between 2 and 65535 for the number of seconds the router should
wait between retry ping attempts, i.e. pings to the second destination address.
7 To simplify configuration, we recommend using only one of the monitor types at any point in time i.e. either
the Consecutive error monitor or the Periodic ratio monitor.
NTC-220 – User Guide
UG01028 v1.2 March 2019
Figure 59 – Failover configuration –Ping monitoring method
55 of 193
© NetComm Wireless 2019