NetComm NTC-220 User Manual page 71

I T E M
DPD keep alive
time
DPD timeout
SA life time
Phase 2 parameters
Remote LAN
address
Remote LAN
subnet mask
Local LAN
address
Local LAN subnet
mask
Encapsulation
type
IPSec encryption
IPSec hash
NTC-220 – User Guide
UG01028 v1.2 March 2019
Enter the time in seconds for the interval between Dead Peer Detection
keep alive messages.
Enter the time in seconds of no response from a peer before Dead Peer
Detection times out.
Enter the time in seconds for the security association lifetime.
Enter the IP address of the remote network for use on the VPN
connection.
Enter the subnet mask in use on the remote network.
Enter the IP address of the local network for use on the VPN
connection.
Enter the subnet mask in use on the local network.
Select the encapsulation protocol to use with the VPN connection. You
can choose ESP, AH or Any.
Select the IPSec encryption type to use with the VPN connection.
Select the IPSec hash type to use for the VPN connection. The hash is
used for authentication of packets for the VPN connection.
Table 19 – IPSec Configuration Items
D E F I N I T I O N
71 of 193
© NetComm Wireless 2019