Operating Modes Of The Hmi - WEG CFW501 V1.8X Programming Manual

4.3 OPERATING MODES OF THE HMI

The monitoring mode allows the user to view up to two variables of interest, one on the main display, and another
on the secondary display. Such fields of the display are defined in
Level 1 allows the user to select the menu items to direct the browsing of the parameters.
Level 2 allows browsing the parameters of the group selected by level 1.
Level 3, in turn, allows the modification of the parameter selected in level 2. At the end of this level, the modified
value is saved or not if the key ENTER or ESC is pressed, respectively.
The Figure 4.3: HMI operating modes on page 4-3
It is the initial status of the HMI after the powering up and of the initialization
„
screen, with factory default values.
The field menu is not active in this mode.
„
The main display and secondary display of the HMI indicate the values of
„
the two parameters preset by P0205 and P0206.
From the monitoring mode, when you press the ENTER/MENU key, you
„
commute to the setting mode.
Level 1:
This is the first level of the setting mode. It is possible to choose the
„
parameter group using the keys
The fields: main display, secondary display, bar graph for monitoring of
„
variable and measurement units are not shown in this level.
Press the ENTER/MENU key to go to level 2 of the setting mode – parameter
„
selection.
Press the BACK/ESC key to return to the monitoring mode.
„
Level 2:
The number of the parameter is shown on the main display and its content
„
on the secondary display.
Use the and keys to find the desired parameter.
„
Press the ENTER/MENU key to go to level 3 of the setting mode- modification
„
of the parameter content.
Press the BACK/ESC key to return to level 1 of the setting mode.
„
Level 3:
The content of the parameter is shown on the main display and the number
„
of the parameter is shown on the secondary display.
Use the and keys to configure the new value for the selected
„
parameter.
Press the ENTER/MENU key to confirm the modification (save the new
„
value) or BACK/ESC to cancel the modification (not save the new value).
In both cases, the HMI returns to level 2 of the setting mode.
NOTE!
When the inverter is in the fault state, the main display indicates the number of the fault in the format
Fxxxx. The browsing is allowed after pressing the ESC key, and the indication Fxxxx goes to the
secondary display until the fault is reset.
NOTE!
When the inverter is in the alarm state, the main display indicates the number of the alarm in the
format Axxxx. The browsing is allowed after pressing any key, and the indication Axxxx goes to
the secondary display until the situation causing the alarm is solved.
illustrates the basic browsing of the operating modes of the HMI.
Monitoring Mode
Setting Mode
and .
Figure 4.3: HMI operating modes
HMI and Basic Programming
Figure 4.2: Display areas on page
BACK
ESC
Parameterization
BACK
ESC
Parameterization
BACK
ESC
Parameterization
4-2.
4
Monitoring
ENTER
MENU
Level 1
ENTER
MENU
Level 2
ENTER
MENU
Level 3
CFW501 | 4-3